How do you get the SRS light off?
How to Turn Off the Airbag Light
- Turn on the ignition switch with your car key.
- Wait for the airbag warning light to turn off.
- Turn the ignition switch of your car back off for a little longer than three seconds.
- Repeat steps 1 through 3 twice to make three times total.
How do you reset the SRS airbag light?
Conclusion – How to Reset Airbag Light
- Turn your ignition on and off.
- Restart your vehicle and do a test drive.
- Examine the passenger airbag switch.
- Inspect whether seat belts are fastened or working correctly.
- Verify that the passenger seat sensor is not applied.
- Use a scanner with an SRS or airbag light reset option.
How do I reset my supplemental restraint?
Put the key into the ignition and turn on the vehicle, making sure you don’t start the engine. The paperclip shorts out the SRS light, thus resetting and turning it off. Plug the SRS power connector back into the fuse panel. Put the cover back on the fuse panel and shut off the vehicle.
Where is the fuse for SRS light?
Where is the fuse for SRS light? The fuse block is on the driver’s side of the engine compartment. Pull out the SRS fuse. In most models, this is fuse #40, located in the lower right corner of the fuse block.
Will disconnecting the battery reset the airbag light?
Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.
How do I turn my airbag off?
How to deactivate your front passenger airbag
- In some vehicles, the deactivation switch is in the glovebox.
- If the switch is in the glovebox, look for the deactivation lock.
- Insert your car key.
- Close the glovebox.
- Check your dashboard.
Will disconnecting battery reset SRS light?
What would cause the SRS light to come on?
If the SRS light stays on or starts flashing on and off, you may have a problem with the airbags themselves, a loose wire, a faulty seat belt buckle, or a problem with the Engine Control Unit (ECU) that is causing the airbag warning light to stay on.
How do I fix my SRS light?
How to Reset an Airbag Light
- Put the key into the ignition and turn the switch to the “on” position.
- Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
- Repeat Steps 1 and 2 two more times.
Why does my SRS light stay on?
Is it illegal to drive with airbag light on?
The bottom line is that, when your airbag light comes on, it’s vital that you don’t drive any further and have your car checked by a mechanic as soon as possible. Until the problem is diagnosed and fixed, your airbags will not deploy.
