How do you reset the check engine light on a Honda Pilot?
Turn the ignition key to the “II” position and wait for the light to stop flashing on the reset tool. This will reset the electronic control unit, or ECU, and turn the check engine light off.
Can you manually turn off check engine light?
You may also need to manually reset the light after making repairs if the code doesn’t clear automatically. The best way to reset a check engine light is to use a code scanner. However, if your vehicle was manufactured before 1996, you can simply disconnect the battery to reset the light.
How do you clear the codes on a Honda Pilot?
Press the SEL/RESET button on the steering wheel until you see the engine oil life display. Select ”RESET” by pressing the INFO ( / ) button, then press the SEL/RESET button to reset the engine oil life display. The maintenance item code(s) will disappear, and the engine oil life will reset to ”100.
How do you reset car sensors?
How to Reset a Car Computer
- Open up the hood.
- Remove the positive terminal cable from the battery using your pliers or wrench.
- Go to your fuse box in your car, and look at the diagram.
- Keep the car disconnected like this for two to three minutes to clear the computer’s memory.
- Insert the fuse back in to the box.
How do you reset the check engine light on a 2003 Honda Pilot?
i found out from the service manual pg. 11-4 to reset the pcm without scan tool: on the front passenger side fuse box, #13 7.5 amp fuse… with the ignition off, pull the fuse & wait at least 10 seconds, then re-install. that should reset the check engine light.
Why is my Honda Pilot engine light on?
When your check engine light comes on, this could be as simple as tightening or replacing your gas cap. One of the most acceptable and frequent cause is that your Honda Pilot gas cap is loose, damaged or missing.
How do you reset the check engine light on a Honda Ridgeline?
Now You want to press the reset button that is below the select button and hold it down for 10 to 15 seconds. After that it will ask You if You want to reset the maintenance and now You will need to press select once and then preSSReset once. Your light should now be reset.
