# How many amps does a refrigerator pull?

The average refrigerator uses 725 watts of power and **10 to 20 amps**. This can equate to roughly 10 percent of your home’s total energy consumption.

## Can I run a refrigerator on a 15 amp circuit?

Most refrigerators run between 3 to 6 amps, with that said, a refrigerator can spike at peak usage up to 15 amps. It’s best to take into consideration worst case scenarios. You should have refrigerators and freezers installed on a 15-20 amp dedicated 120 volt circuit.

## How many amps does a residential refrigerator draw?

According to the United States Department of Energy, refrigerators have an average wattage of 725 watts, which, at 120 volts, computes to an amperage of 6.04 amps.

## Does a fridge need a 20 amp circuit?

Refrigerator Circuit

A modern refrigerator requires a dedicated 20-amp circuit. You may currently have a smaller refrigerator plugged into a general lighting circuit, but during any major remodeling, install a dedicated circuit (120/125-volts) for the refrigerator.

## How many amps does a microwave pull?

The microwave ovens consume power at a rate of 650– 1200 watt, which equates to a current of around 10 Amps.

## How Many Amps Does A Refrigerator Pull

## Can I plug a refrigerator into a regular outlet?

Refrigerator – Most refrigerators work with a standard 100-120 volt electrical plug and outlet. You will notice that the electrical plug is made up of three prongs; this means you will need an electrical outlet that has three inserts.

## Does refrigerator need 15 amp outlet?

Refrigerator. The fridge requires a 5 amps connection, usually provided close to the ground.

## Can you run two refrigerators one outlet?

Refrigerators are considered noncontinuous duty loads. Loads that draw current for less than three hours at a time are allowed to be on the same circuit with other noncontinuous loads, as long as the total load does not exceed the circuit breaker rating.

## How many appliances can run on a 20 amp circuit?

Conclusion. The maximum number of electrical outlets you can run on a 20-amp circuit is ten. Ten outlets will power devices and appliances without exceeding the 80% capacity rule for residential electrical wiring.

## Can a microwave and refrigerator be on the same circuit?

According to the 2020 version of the NEC, you can’t power a microwave and refrigerator on the same circuit because each of these appliances requires a dedicated circuit, which is one shared by no other appliances or lights.

## How many amps does a dishwasher pull?

Household dishwashers use 10 amps of power, mostly. Having said that, your breaker should be on a higher rating than the appliance being used for safety purposes.

## Should fridge be on own circuit?

In the US, under the NEC, a residential kitchen fridge is not required to be on a dedicated circuit. It is certainly a good idea and best practice, but not a requirement. A fridge can be on one of the minimum two required “small appliance branch circuits”.

## What size breaker is needed for a refrigerator?

A 115-volt or 120-volt, individual, properly grounded branch circuit with a 3-prong grounding type receptacle, protected by a 15 or 20 amp circuit breaker or time-delay fuse. Should be on a dedicated circuit. This is recommended for best performance and to prevent overloading house wiring circuits.

## Do I need a 15 or 20 amp outlet?

Standard 15-amp receptacles are suitable for typical household appliances, lamps and other accessories. A 20-amp receptacle is for heavy-duty appliances and power tools, such as air compressors. Residential garages occasionally have 20-amp receptacles to accommodate larger power tools.

## Is it OK to plug a refrigerator into a GFCI outlet?

Residential Kitchen. In a dwelling unit (residential), GFCI protection is only required for kitchen receptacles that serve the countertop surfaces. There’s no requirement to GFCI protect receptacles that serve a refrigerator. Unless the fridge is plugged into a countertop receptacle.

## Can a refrigerator be on an extension cord?

Extension cords with a lower gauge number—like 10 or 12 gauges—are considered heavy-duty cords because they have a higher capacity to deliver power. Since the 10-gauge cord is an extra heavy-duty extension, it makes the best choice for big power loads like a refrigerator.

## Can a refrigerator trip a GFCI?

Reset the GFCI Outlet

The first step is to check the GFCI outlet. When your refrigerator turns off and it is plugged into a GFCI outlet, it could have simply been caused by “nuisance tripping.” It’s called that because the GFCI is very sensitive and can randomly trip when it shouldn’t.

## How much power does a refrigerator draw?

Domestic fridge power consumption is typically between 100 and 250 watts. Over a full day, a fridge records between 1 to 2 kilowatt-hours (kWh) of total energy usage, or about $150 per year per fridge. These figures can be validated for your refrigerator by using a plug-in power meter like this.

## How many amps is the average house?

Most homes have an electrical service of between 100 to 200 amps. Amperage is a measurement of the volume of electricity flowing through wires, and this measurement can vary between 30 amps in very old homes that have not been updated to as much as 400 amps in a very large home with extensive electric heating systems.

## How many amps does a computer draw?

By our estimates, gaming PCs draw an average of 300-600 watts. At 120 volts supplied, that’s between 2.5 and 5 amps.

## How many amps does a washer use?

A washing machine typically uses between 12 and 15 amps of electricity, while a fridge typically uses about half that amount. This means that you can usually have a washing machine and fridge on the same circuit, but it’s always best to check with an electrician to be sure.

## Can I use a 20 amp outlet on a 15 amp circuit?

Electrical plugs designated as 20-amp will not fit into 15-amp outlets. A 15-amp circuit is usually served by 14-gauge wire and is protected by a 15-amp circuit breaker or fuse.

## How many outlets can run off a 15 amp breaker?

Technically, you can have as many outlets on a 15 amp circuit breaker as you want. However, a good rule of thumb is 1 outlet per 1.5 amps, up to 80% of the capacity of the circuit breaker. Therefore, we would suggest a maximum of 8 outlets for a 15 amp circuit.