What does a flashing light on a dishwasher mean?

W

What does a flashing light on a dishwasher mean?

Common solutions for: Dishwasher lights flashing or blinking. The heating element heats up the water to operating temperature. If the water doesn’t reach the proper temperature after a set amount of time, a light on the control panel might start flashing. If the heating element does not have continuity, replace it.

Why are the lights on my Hotpoint dishwasher flashing?

flashing lights is the error code for the anti flood switch activated. What you need to do is pull the dishwasher out and tip it 45 degs backwards. This will allow the water to drain out from the base so you may need a towel for this part. Then retry the dishwasher and see how it goes from there.

How do you reset Ariston lbf 5b dishwasher?

Switch off the appliance by pressing the ON/OFF button, switch it back on after approximately one minute and reset the program.

Do I need salt in my Ariston dishwasher?

Dishwasher salt is recommended to keep the machine working efficiently and to get the best possible wash results. The dishwasher salt is available through Harvey Norman, or from the Ariston website shop. In the meantime if you want to run a wash you can put water in to the salt compartment so the machine stops asking.

Why is my start button blinking on my dishwasher?

If the start button light is blinking, then the dishwasher has been reset, and the appliance is in the midst of shutting off. It may blink for up to 90 seconds to indicate it is completing the shutting down process.

What to do if your Ariston dishwasher is locked?

• Turn on the tap and the appliance will start after a few minutes. • The appliance is locked because no action was taken when the Salt and Rinse Aid indicator lights were flashing. Switch off the machine using the ON/OFF button, turn on the tap and switch the machine back on after 20 seconds by pressing the same button.

Why is the 1st LED blinking on my dishwasher?

1st LED only blinking is a tripped float switch. The over flow under the dw needs to be emptied. led’s 1 and 2 is no drain. Drain Motor problem. Clogged filter. Faulty pressure switch. Plugged drain line. New disposer with knock out plug still in it. Main Motor, pressure switch, or blocked filter.

How often does a dishwasher fault code flash?

At the end of the wash cycle the light will flash slowly (about once a second.) normal machine operation. When the electronic control system detects a fault with the machine one of the lights will flash rapidly. If a from the fault code displayed. The four program indicator lights display a four-digit binary code. If a light in on then a “1” is

Why is there no water coming out of my dishwasher?

No water drains from the dishwasher. • The dishwasher cycle has not yet finished. • The drain duct is blocked. • The filter is clogged up with food residues. The dishwasher makes excessive noise.

About the author

Add Comment

By Admin

Your sidebar area is currently empty. Hurry up and add some widgets.