How do I stop my hazard lights from flashing?
To stop the hazard lights from flashing, you need to press the reset button under the dash or press unlock on the remote, if you have one. Your owners manual will show you exactly where the reset button is under the dash.
How do I reset my Subaru battery after replacing it?
Open the window completely and then press and hold down the power window switch for approximately 1 second. 4. Close the window completely and then pull and hold the power window switch for approximately 1 second.
Why are all the lights on my dashboard flashing?
When Your Dashboard Lights Flicker and Your Car Won’t Start If the car won’t start at all and the dashboard lights are flickering, it’s likely that the battery does not have enough charge to crank over the vehicle. Bad battery due to a failed alternator. Dirty or loose battery cables. Faulty ignition switch.
What does a blinking battery light mean?
A fault with the alternator is probably the main reason for a battery light to flicker. It means your battery has taken over to keep the electronics working. As soon as the output from the alternator drops to a certain fairly low level, the battery light flickers.
Why do my lights keep flashing on my 1997 Subaru Legacy?
1997 Subaru Legacy Outback wagon – Emergency flashers became activated and continued to flash even after the dashboard emergency flasher switch was cycled to the OFF position and the ignition key was removed. SOLUTION: 1. Disconnect the positive battery cable.
Can you reset the parking lights on a 1999 Subaru Impreza?
Whenever you replace the battery in your 1999 Subaru Impreza, the parking lights, as well as the radio and dash lights will flash until you reset the security system. Resetting the system is not done with a scan tool — these three methods are the only ways to reset the system.
How do I Turn Off the lights on my car?
Simply cycle the door locks with the key fob and the lights will stop flashing. The second method is using the security button under the dash. The button is mounted to the bottom of the dash, next to the hood release lever. Push the button and hold it for three seconds, while at the same time turning the ignition switch to the run position.
What to do when your car lights keep flashing?
Make sure all doors,hood and trunk are closed,lock car with key ,hook battery up, and while lights are flashing unlock driver door with key.lights stop flashing,your good to go. 24 people found this helpful. 98 legacy wagon flashers continued with ignition off.
